Category: Uncategorized

The Varian 500 is back to its pre-summer 2018 configuration, where it is good for long 13C experiments, 1H and 2D experiments.

Read More

The Varian 400 in room 37 has now been set up to do 1H, 19F, and 31P automatically.  As these are all fast experiments, there is no need to sign up for time any more.  Just go ahead and run.  If someone is waiting, limit yourself to two samples.

Read More

To get the best results from the QANUC 500, you should tune on your sample. This is done automatically with the Protune module, if you choose the experiment Proton_withtuning. Do this before a 2D experiment, if your sample is not concentrated, or if you are doing quantitative work. You don’t need to run the experiment Proton – you can drag this to the trash. Instructions are on the manuals page.

Read More

The Varian 400, in room 37, is up again! It’s now set up for 13C, 1H, and 19F. It’s pretty quick because there is no need to tune. New booking rules are at the instrument page.  Manuals and a description of the possible experiments are at the manuals page.

Read More

The McGill TopSpin addons have been updated.  These are plot layouts and automation routines which simplify and improve processing.  Instructions are available at http://nmr.chem.mcgill.ca/en/nmr/manuals.  Get the addons themselves by emailing Robin.

Read More

There will be a power outage in the NMR rooms on Friday, Sept. 21 from 9 to 11 AM.  The instruments will be turned off beginning at 8 AM.

As far as I know, only the NMR rooms are affected.

Read More

We’ve got the Mnova licenses for 2018-2019.  The old ones will still work, but if Mestrelab introduces a new version of software, you’ll need the new ones.  Ask Robin for the new licenses if you don’t have them.

Read More

A brief summary of installing and using TopSpin is available here.

Read More

Instructions for downloading, installing, and getting a license for TopSpin 4 are now up.  Click here to see them.

Read More

Come to room OM10 with your laptop to participate in a hands-on processing workshop about using TopSpin and Mnova.

  • 1 PM: installing software
  • 1:30-2:30: guided data processing workshop

Don’t forget your laptop!

Read More